87-89 integra rods
 

Ok so now i know that you can put these in to a D16A6 but will they fit my stock pistons/pins or do i need the integra pistons as well? also if taking out my pistons do i need to hone out the block and get new rings before i put the pistons back in? and do i have to re-ballance the rods or can i just simply put everything together without a hassle?

Re:87-89 integra rods
 

The correct way would just take the pistons and rods to the machine shop and have them pressed in.

Re-honeing the block? yes, I probably would put a quick hone job on the cylinder so the rings would seal.

Balancing the bottom end? well, technically you should since the 87-86 rods are heavier than the stock ones, but I am sure you could do it without problems. Lots of people slap in eagles/crowers without doing a thing.

JEff

Re:87-89 integra rods
 

Posted by: AbaZ Posted on: Today at 12:52:20pm
"The correct way would just take the pistons and rods to the machine shop and have them pressed in.

Re-honeing the block? yes, I probably would put a quick hone job on the cylinder so the rings would seal.

Balancing the bottom end? well, technically you should since the 87-86 rods are heavier than the stock ones, but I am sure you could do it without problems. Lots of people slap in eagles/crowers without doing a thing.

JEff"



How much will all of that cost at the machine shop? and are the integra rods stonger than the a6's?

Re:87-89 integra rods
 

yes they are stronger, how much stronger? I have no idea, they are just "beefier" in size, so they should support more HP.

How much would a machine shop charge? I dont know.. pick up a phone book and call around. Each machine shop has different prices.

Jeff

Re:87-89 integra rods
 

How much do you think i can get the integra rods for at a local wreckers?

Re:87-89 integra rods
 

you should probably go and call them to find out, because I have no idea..

40 bucks?

Re:87-89 integra rods
 

hell i wish it was 40, lol, around here in the london ontario area, the wreckers guys are fucken jerks, i had to pay 160 bucks for my STD manifold from a D16Y7

Re:87-89 integra rods
 

So you actually shelled out and bought it for 160? ::)

eh... you probably could have bought one from Winnipeg for $20-$40 and had it shipped for like ten bucks...

Re:87-89 integra rods
 

youre serious? it was with the cat converter on it, but man hook me up where do you get parts that cheep in winnepeg?

Re:87-89 integra rods
 

everywhere... LOL

Re:87-89 integra rods
 

Dude, parts out west are dirt cheap for some reason. I have friends out there who get sets of rims for $80.

Re:87-89 integra rods
 

..again.. probably stolen.. ;D

Re:87-89 integra rods
 

Hahaha... I wish. That'd make me feel better for living out here. They're picking up old Riken, Enkei, and SSR stuff at the wreckers. for cheap. dammit.

Re:87-89 integra rods
 

---- get me a pair of ssr rims for 80 bones, i wish

Re:87-89 integra rods
 

no. not pair. SET. (that's in Canadian funds too...)

lucky bastards, they are.