.63/.60 is fucked, what do I do??
#1
.63/.60 is fucked, what do I do??
The .63/.60 t3 I bought has a fucked center section, because the guy I bought it from didn't hook up the water lines and over heated it. There's some shaft play, a little more than minimal.
The housings are fine, so I was thinking either buying a new cartridge(?) or just getting a new t3/t4 and if the new turbo doesn't have the turbine housing I want, then I can swap my .63 housing over?
I seen a couple turbos on ebay that are supposed to be t3/t4 from down2turbo and ssautojunk, but they come with stupid turbine housings like .84.
What should I do?
Stan
The housings are fine, so I was thinking either buying a new cartridge(?) or just getting a new t3/t4 and if the new turbo doesn't have the turbine housing I want, then I can swap my .63 housing over?
I seen a couple turbos on ebay that are supposed to be t3/t4 from down2turbo and ssautojunk, but they come with stupid turbine housings like .84.
What should I do?
Stan
#5
Re:.63/.60 is fucked, what do I do??
Originally Posted by yellowcrx6
i dont think hes updated them to his homepage yet. send him a pm cuz he told me about them as well. he said they would get up on the site soon, but just not yet
#8
Re:.63/.60 is fucked, what do I do??
Originally Posted by Stan
Sounds like a good way to go, I wonder if the wheels are balanced?
Stan
Stan
#9
Re:.63/.60 is fucked, what do I do??
i have been hearing some noises from my car, hit up my buddies work so he could hear it, first he chinged the said "TURBO.....thats the sounds it makes when the blades are scraping the housings..." i was affraid he would say that cuz thats what i was thinking...same turbo too, 60/63...