HomemadeTurbo - DIY Turbo Forum

HomemadeTurbo - DIY Turbo Forum (https://www.homemadeturbo.com/)

- Forced Induction (https://www.homemadeturbo.com/forced-induction-7/)

- - zc with a t-3 (https://www.homemadeturbo.com/forced-induction-7/zc-t-3-a-8350/)

zerox298

08-07-2003 08:21 AM

zc with a t-3

Just bought a t-3 with a/r's of.42 turbine side and .48 compressor side is this good for a zc if not what would be the best? thanks

RENR	08-07-2003 03:40 PM

Re:zc with a t-3

that should be ok, but you might want to go bigger later on.

Tom-Guy

08-08-2003 02:31 AM

Re:zc with a t-3

The .42 compressor housings are just that... .42 AR. The compressor wheel itself is actually .50 trim, good for 250-ish.

Sounds like about all you care to push on stock D16 bottom end. I'd go higher, but only for short spurts and I'd be expecting it to die.

All times are GMT -5. The time now is 12:36 AM.