Will a T25 bolt into my T3 exhaust housing?
#1
Will a T25 bolt into my T3 exhaust housing?
I currently have a bad t3 on my turbo Jeep project. I bought a t25 from a Turbo Sunbird from Ebay today. After a little research, it seems that the t25 has a smaller mounting flange than the T3. Is there any possibility that I could put the compressor and cartridge from the T25 into my T3 housing that is already mounted on my Jeep?
I used to have a Conquest with a Mitsubishi turbo, and I remember something about the exhaust wheel being the same size as other turbos. (12A stock vs. the 16G I put in the car.)
Thanks,
Rob
I used to have a Conquest with a Mitsubishi turbo, and I remember something about the exhaust wheel being the same size as other turbos. (12A stock vs. the 16G I put in the car.)
Thanks,
Rob
#6
Re: Will a T25 bolt into my T3 exhaust housing?
Don't get discouraged; they make reducers if you still want to use that turbo.
I used a T25 on my T3 flange. All I had to do was drill some new studs and it worked.
Here's a picture if that helps.
I used a T25 on my T3 flange. All I had to do was drill some new studs and it worked.
Here's a picture if that helps.
#8
Re: Will a T25 bolt into my T3 exhaust housing?
Originally Posted by Skaterdudz02
Don't get discouraged; they make reducers if you still want to use that turbo.
I used a T25 on my T3 flange. All I had to do was drill some new studs and it worked.
Here's a picture if that helps.
I used a T25 on my T3 flange. All I had to do was drill some new studs and it worked.
Here's a picture if that helps.