What to do with lines on intake pipe, ie. crankcase breather, pcv?? i dunno
 

Ok there's like 3 lines going into the intake pipe near the TB... one is the temp sensor i think, and one goes to the crankcase and one i have no idea right now...

what do i do with these when i boost?? also i heard all this contraversy about the PCV system and catch cans etc... what's the deal?

Re:What to do with lines on intake pipe, ie. crankcase breather, pcv?? i dunno
 

Put a filter off the valve cover crank ventalation. Then there is a hose that goes along the fuel rail with an in and a out. It is a steel line just cap off both ends, then for the intake temp sensor just zip tie it out of the way. You should be fine. At least this is what I did and not CEL's. I would be interested in hearing what others have done. I was debating if I should drill my chargepipe and put the intake sensor in, but for now runs fine. So no worrys.

Re:What to do with lines on intake pipe, ie. crankcase breather, pcv?? i dunno
 

I think if u tap your charge pipe and put the intake air temp sensor in there it will see a HOT air charge (turbo heats it up) and then retard timing.

Re:What to do with lines on intake pipe, ie. crankcase breather, pcv?? i dunno
 

so what to do with the temp sensor?

what's the third line again? i don't have my engine or car so i don't remember.... stupid honda taking so long

Re:What to do with lines on intake pipe, ie. crankcase breather, pcv?? i dunno
 

Re:What to do with lines on intake pipe, ie. crankcase breather, pcv?? i dunno
 

keep your iat sensor in. at higher boost just secure it in tighter with zip ties. it shouldn't see hot air if you are running an intercooler. cap the breather hose with a bolt and hose clamp in it and filter on the valve cover. the third hose i don't know what you're talking about...mine had only the first two.

Re:What to do with lines on intake pipe, ie. crankcase breather, pcv?? i dunno
 

dunno about third, will see when my car comes back

Re:What to do with lines on intake pipe, ie. crankcase breather, pcv?? i dunno
 

Could it b your EGR?

Re:What to do with lines on intake pipe, ie. crankcase breather, pcv?? i dunno
 

yes egr probably.. so what do i do with the hole PCV and EGR system, on honda-tech they had al,l this argument about running a catch can and you can't just use breather or something cuz the breather line needs vaccum to help seal the rings? wtf

Re:What to do with lines on intake pipe, ie. crankcase breather, pcv?? i dunno
 

For the EGR you can just block both ends off i'm not sure about the PCV system though