bored

okay once the flaming is done, could someone tell me if i can use my intercooler for vacuum to the BOV and to the the external waste gate, it has four holes on it which where intended for running bolts through to hang the manifold but im thinking since it sits fine with two (its a small side mount) can i use the other two for vacuum or ---- it just seal em up

AWDstylez

No you can't. Vacuum sources need to be after the throttle body. If you ever run an electronic boost controler you'll need one of those ports, but aside from that cap them off.

See, not so hard. No flaming at all. (yet)

bored

thnx.

bitchasscracker

go kill your self







sorry i had to

bored

loool

**** is next in queue...

d-man

You better believe it.

bored

wtf then why does this seem to exist:

http://www.honda-tech.com/zerothread...ostid=28748456

klyph

You mean Honda Tech? I have no idea why that exists

bored

looks like u exist because ur old man was too tite for a rubber, someone got a proper reply?

AWDstylez

I was too lazy to read more than the first 4 words of the first 5 posts. So I'm going to guess you're talking about the top port on the wastegate that goes to a boost source pre-throttle body. That's for electronic boost controllers like I said in my original reply. You don't have to worry about that if you're using a manual controller.

If that's not what you were refering to, then give some cliff notes on that topic. Everyone here is too lazy to read that much.