Eh, didn't know you were doing anything. Good ---- though, get a new clutch.

 

I know all about roasting clutches. A bus tried to run me off the road a couple weeks ago and I was pissed so I banged it into 2nd and it went straight to redline

 

no prob coon poon pounder
you owe me some chip love haha
ssauto chip inc, i like it.

 

Post some pic's.

 

ill post the pics in a sec, gotta go get my camera.

uploading as we speak. anyways, we used a ------ h22(f22?)stock tube mani for the wg dump, used a plumbing access plate to make the flange. welded it up with the HF, had to only make two real cuts in the runners if i remember right, that bitch that runs from 4 over to by 1 i think, we cut in half. the rest were just lopped off and welded up.

here they are, all 400 of em :

 

im getting better.. enough to get a better welder. it's holding my ability back when i try to do better it seems. max 2 and min 1 can only go so far with wire speed

 

la bump because the thread deserves it

 

Yep anything with a hx35 deserves it

 

Holset power FTW

 

+1