|
Re: Turbine Blade Clipping???
i dont think so, why dont you go to a 14b instead of the T25? Its considerably bigger in the compressor and turbine section
|
Re: Turbine Blade Clipping???
because the t-25 was free
|
Re: Turbine Blade Clipping???
I read somewhere that clipping reduces efficiency. think about it, if it's letting exhaust out easier that means that the turbine isn't going to spin as much because the exhaust is getting around it without having to push it out of the way as much, so you'd get more lag.
|
Re: Turbine Blade Clipping???
Originally Posted by accordepicenter
If you need more exhaust flow, get a bigger housing... Ive seen the dyno charts of clipped turbines and it wasnt worth the added spool up time because the clipping only helps soo much, you need a bigger exhaust housing. If you have a .48 T3 exhaust housing, go to a .63 T3, thatll give you a power gain and the .63 is equal to a .48 stage 2. If you need more exhaust flow then that, go to a stage 3 turbine (i think i have one around here i can sell if you want)
Won't you need a bigger fin or spindle set-up on the exhaust side then? JP |
Re: Turbine Blade Clipping???
not on a t3 if you switch the a/r of the housings, they are the same size... but flow differently... this only applies to turbines though, i imagine a t25 you could get a bigger housing for too maybe.. but i bet itd be hard to find.
|
| All times are GMT -5. The time now is 02:46 AM. |
© 2024 MH Sub I, LLC dba Internet Brands