TubroXS RFL BOV
#1
TubroXS RFL BOV
I am doing my install, and i pushed it down on the flang and tightened up the little screws, and it still moves a little little bit back and fourth on the flange, is this ok? or is it sopose to not move at all on the flage. Does it matter?
#3
Re: TubroXS RFL BOV
Why would you possibly think it is supposed to move around on the flange?
NO, thats NOT ok
Sounds like one of your flanges are warped. Either flatten them out on the belt sander or head over to autozone and grab some THICK gasket material and make up a squishy gasket to seal it
You cant run it like that, you wont build boost
NO, thats NOT ok
Sounds like one of your flanges are warped. Either flatten them out on the belt sander or head over to autozone and grab some THICK gasket material and make up a squishy gasket to seal it
You cant run it like that, you wont build boost
#4
Re: TubroXS RFL BOV
When I got my 1st DSM I thought a loud BOV was soooooo ------- badass lol. I got a real RFL and vented that bitch on a stock mass air sensor ahahaha. God I was such a ricer for like 3 months. Anyway, the point is that it sucked ***. It leaked at only 17psi on a 16g and was a big piece of ----. I can't imagine the knock-offs would be any better, but IDK how they could be worse. I say ditch your knock-off and get a 1G bov. IDC what anyone says, the 1G is better than the RFL or Really ------- Lame.
Thread
Thread Starter
Forum
Replies
Last Post