Toyota 2AZ-FE turbo?
Im thinking of fitting a turbo to my 2AZ-FE 2.4 litre engine with a 9.6:1 compression ratio, im guessing 6 to 7 psi will be a safe boost for this cr and stock pistons and as im only looking for 200 flywheel horse power it may even be a lower boost than that, anyone here got any experience on this engine or at least boosting an engine with this compression ratio?
|
I run 6.5 psi in an engine with 9.3:1 cr, plan to up it to about 9 psi. Engine completely stock, 100 RON octane, no issues.
I think you should be allright with the boost you mentioned. |
I was running 9 PSI on a 10:1 cr engine. For every PSI i took out one degree of timing to be safe. I guess it was very conservative, because although I felt the increase in power, I'm pretty sure more power would have been possible with 9 PSI. I used 98 RON.
|
Movement on this at last, i finally got time to test fit my turbo and manifold (i wasn't about to buy more stuff if it didn't fit) and it fits :D:D:D:D:D
I have now been on a spending spree and have intercooler (from an MR2) external waste gate, Aeromotive rising rate fuel pressure regulator and a oil feed kit for the turbo..... im getting a custom made down pipe made up on Wednesday and then the fun will begin, the only issue i haven't got sussed exactly is the oil return, i know its possible but i haven't yet finalised plans exactly, will take sump off to investigate where to drill..... work begins proper on Thursday. |
1 Attachment(s)
|
2 Attachment(s)
Mark !!! Your turbo looks beautiful.
I'm using the same manifold on my car. I've got a 2008 Scion xB2. I built the entire thing myself with an eBay kit, so I know exactly what you're going through. It is a major PITA, but the rewards are amazing. Currently, my wastegate is set to about 5 PSI, but since my car is completely stock otherwise, I haven't really pushed the car close to that amount of boost. I always quarter/half throttle it to avoid running lean. Other than that, I haven't had any major engine issues. Um ... the oil return, I tapped into the oil pan with some AN fittings that were bolt on. I'm not sure if we have the same pan and clearance on the inside, though. Here's a picture of my setup as of now. https://www.homemadeturbo.com/attach...1&d=1476777330 I'm really looking forward to seeing your finished product. |
All times are GMT -5. The time now is 06:08 PM. |
© 2024 MH Sub I, LLC dba Internet Brands