Re: though i should share i pick for you fuckers who blow couplers
 

+2, theres no indentions where the metal was deformed, one crimp at a time. unless they had a wicked sweet setup on an english wheel.

i wonder if similar could be acomplished with one of those exhaust tubing expanders wiht ---- welded on. like the ones that ------ when you tighten them down.

Re: though i should share i pick for you fuckers who blow couplers
 

you need the mating opposite side.

Re: though i should share i pick for you fuckers who blow couplers
 

use a red scuff wheel on an angle grinder and clean up doo-doo scratches.....nice work....i've been wantin to do this...

Re: though i should share i pick for you fuckers who blow couplers
 

I kept blowing a coupler too, except I cannot do that due to using thick 2 1/4 exhaust mandrel bends so I just busted out the welder and ran a bead. Works just as good, and you don't see it. Totally homemade.

Re: though i should share i pick for you fuckers who blow couplers
 

Yeah, I could see this working, but not that cleanly

Re: though i should share i pick for you fuckers who blow couplers
 

whoops.. kinda asleep when i saw this..... looks tits man

Re: though i should share i pick for you fuckers who blow couplers
 

http://www.harborfreight.com/cpi/cta...emnumber=34104 .....