T3 to T3/T4 turbo question
 

I recently purchased a tubro manifold from someone who calimed it was a T3/T4 turbo manifold. Today I finally found a turbo that wasnt beat to crap and it doesnt fit my mani. I am assuming the manifold is a T3 because it is smaller. The bolts line up in length, but the turbo is wider then the mani. Does anyone have any suggestions on how to fab these to fit together?

Re: T3 to T3/T4 turbo question
 

lol
t3 and t3 / t4 have the same footprint.

Re: T3 to T3/T4 turbo question
 

if the bolts line up, you're good to go.

Re: T3 to T3/T4 turbo question
 

the bolts line up one way, but not the other way.
circles=bolt holes

Manifold
0---0
0---0

Tubro
0---0
------
0---0

Re: T3 to T3/T4 turbo question
 

you need to post some pics. you might have a t4 turbine housing.
t3
Bolt Center Width 3.40
Bolt Center Height 1.75
t4
Bolt Center Width 3.25
Bolt Center Height 2.75

Re: T3 to T3/T4 turbo question
 

ill post pics up tomorrow afternoon.

Re: T3 to T3/T4 turbo question
 

Or it might be a manifold for a mitsubishi turbo i.e. 14b, 16g, etc. I know they still have a square bolt pattern, just a round hole leading into the hot side.