stalling out?HELP
 

So I have a turbo d-series(d16z6)and for some reason it keeps stalling out when the car is warn enough the tach needle will jump all over and the car shuts off an will not go anywhere until its cold seeing if of any of you gurus could help me out I have replaced plug wires,cap,rotor an put in a coil an it fixed it for about 1 day until it went back to being a bitch..its on stock management and injectors an fmu ...I know its a bad setup but don't got funds to tune until next week...any help is appreciated thankz

Re: stalling out?HELP
 

NO ONE....sad day ???

Re: stalling out?HELP
 

It's the ignitor.

Re: stalling out?HELP
 

If I replace it I have to solder it or pull from the connector don't know how reliable the dizzy will be after

Re: stalling out?HELP
 

Nope..I think you have to take out a screw is all,,and the rest just unplugs. Unplug it one wire at a time that means pull one wire off the old one and plug it in to the same spot on the new one.then go to the next. theirs only like three wires though. it really easy.

Re: stalling out?HELP
 

i just dont want the car takin a ---- on me in the middle of me gettin to work

Re: stalling out?HELP
 

i think i should replace the dizzy but ill try the ignitor and test run it and drive an see whats up

Re: stalling out?HELP
 

yeah it was the ignitor but before i could test it i took a quick break to go to the store and i get back and my lil couzins were playin catch with the dizzy and dropped it and broke the 2 prongs off the end that goes in the head so i had to replace it and it runs fine so far thankz

Re: stalling out?HELP
 

DOHHH!!...ROFLMAO...I can actually visualize that ---- happenin'...Thanx 4 tha laugh...