size of oil and coolant lines
 

what size of oil lines and coolant lines should i run on my 4ag
and whats the best source to tap off of.

Re: size of oil and coolant lines
 

I run 4an oil.. 1/2" ID coolant.

Re: size of oil and coolant lines
 

ok whats 4an

Re: size of oil and coolant lines
 

A size

Re: size of oil and coolant lines
 

ok got it
where is a good source to tap from.

Re: size of oil and coolant lines
 

Most people dont run the coolant lines (my self included) since my turbo only cost me $40 and its not a great loss. But if u were to do it, the best and most common place would be right under the TB. There is a small line. I did this on a 14b and all the hardware came in a "fix a compresor hose kit". Just find the fitting that fits ur turbo and w/e size goes on the other side is what ur using.

ps. dont forget to unplug the WG line so u can get max water flow to ur turbo. :y

Re: size of oil and coolant lines
 

Oil feed - 1/8 [3an] - 1/4 [4an]
Oil drain - 5/8 [10an] +
Coolant - ---- coolant lines if it aint ball bearing :-* [1/4,5/16,3/8 will work]

Re: size of oil and coolant lines
 

im just thinking about temp. if its going to help my temp any bit thats good.
less things to burn up like my brake master cyl or my starter etc.

thanks for all the input. im going to go to home depot and find stuff now.

Re: size of oil and coolant lines
 

IT will help somewhat, but not enough to be noticed.
You need a heat shield - use a cut up aluminum pot.
Put wrap around *any* parts within about 5" of that turbo that aren't made for heat...

A typical place to run cooling lines from is the heater feed.