Quick Oil Feed Question
 

I've got a Stealthmode oil line kit with the dual outlet block fitting and am going to add the oil pressure restrictor.

I'd like to have the restrictor on the firewall instead of on the block itself, so I need a new short stainless line and fittings for this.

My question is: what is the name of the fitting that the oil-line end utilizes. I know the non-flared part is a 1/8 NTP but need to know what the flared fitting at the ends of the SS oil line is. ?

I want to get some parts at my local car store today to get this working, I'm killing my turbo seals.

Re: Quick Oil Feed Question
 

If you have a -4 feedline, the fitting is referred to as a -4an to 1/8npt male to male. If you have the new -3 kit its -3an to 1/8npt male to male.

For a firewall kit you're going to need about 18" of hose with hose ends, a -? to 1/8 to go between the block fitting and the "firewall line" and a -? to 1/8npt male fitting on the firewall side of that line. Then you will need some type of adaptor or T that has two 1/8npt female ports. The firewall line goes in one, the restrictor goes in the other. Then run the feed line off the back of the restrictor.

Re: Quick Oil Feed Question
 

Thanks man. I've got the older kit, so its -4AN

If you wouldnt mind, could you check over this?

http://jess.aspeedracing.com/pressure.gif

Re: Quick Oil Feed Question
 

yes. Between the purple and green is where these male to male fittings will go. It's the same ones that I use in the kit on the hose ends.

Re: Quick Oil Feed Question
 

Saweet. I got that ---- hooked up. Still gotta fenagle with the restrictor but the turbo isnt smoking anymore. Got some other odds-n-ends taken care off too including hooking up my wideband. I'm runnign 8.9:1 WOT. yay! room for improvement :)

Re: Quick Oil Feed Question
 

i like ur drawing