HomemadeTurbo - DIY Turbo Forum - Ostrich and tunerpro

So I laid down a reasonable tune and was going up to xenocrons shop on saturday to hang out and he offered me a couple pulls on his dyno. So I said yea sure, let me get a chip burned so I don't have to drive around with the ostrich for now since I am ok with the tune for the time being.

Using the same bin I have open in tunerpro, I burn it using my burn1 and pop it in... car is VERY lean at idle (high twenties +, stumbles and dies) and if I hit the gas it cuts out terrible misfires (so, WAY too lean). So I went back and grabbed my orginial basemap and it fired up the car, ran it great. So I copied the basemap fuel tables over to the "emulated" bin and tried to start the car, same thing. Adjusted the injector constant from the .31 it should be all the way to .38 and still way too lean.

What gives? Pop the ostrich back in, same bin on it runs great. Pop the burned bin, even enriched, runs HORRIBLY lean, wont even move under its own power.

Also, I noticed that I can switch MAF tables with the ostrich easily, but when I try to burn a chip with a different MAF table, no go. HMM.

I thought the ostrich was supposed to act exactly like the chip but its not even close. More testing tonight. Sucks to have a max of 30 mins a day to mess with the car.