Is this ok for an oil feed?
#1
Is this ok for an oil feed?
I bought a 2 inch extention to run of the block to my Tee fitting the from the Tee im running hard brake line. I just used the regular farrels, and 3/16's line then another farrel and put it straight into the turbo, Im getting insane amounts of oil into my charge pipes, wonndering if the 3/16 line is to small and making alot of pressure?
thanks
pat
thanks
pat
#2
Re:Is this ok for an oil feed?
3/16" is -3 AN, which is what almost all the oil line kits use. You need to check your oil pressure to know for sure. It shouldn't go over 60-70 psi. If it does, a needle valve should help. If not, the seals in your turbo are fried and it's time for a rebuild.
Thread
Thread Starter
Forum
Replies
Last Post
eastbay92cx
Forced Induction
7
01-21-2005 04:40 PM
HMT-Admin
Forced Induction
7
12-13-2003 02:10 AM