Hey guys

Im to lazy to type, so ill just copy and paste what i wrote to leed over MSN.

Im havin problems with my oil return. Ive already welded a pipe onto it but its to far to the right and the downpipe is in the way.. so i wondering, on the sump , theres a deep bit, then theres abit that is very high .. the bit where the exhaust goes under.. ias wondering if i could put a reutrn there?


Cheers

 

Whever u put the return, it just needs to be below your oil level. D series pans are cheap, go pick up another one.

 

dont u mean above?

 

My oil return line is high on my pan, is this a problem? I was told to keep it high. Its way lower than the output from the turbo.

 

u want the line to be over the oil level so the oil in the return line can actually flush out with ease

 

Its a B Series pan. So if i put it on the high part of the sump itll be ok?. The high part meaning the part where the exhaust goes under

 

higher the bettter, just dont have any long bends in the return.

 

wrong.. above your oil level

 

Christ you dicks. It was quarter till 5am when I wrote that post. Yes I meant above!

 

yes, again it should be ABOVE oil level, hence the highest location possible.