Speedracer32

guys
i got just about everything lese hook up except this oil drain line buti cant get the oil pan off
got all the bolts out and unbolted the braCKETS

anyone got any ideas?
trying to get it off tonight so i can get it back on and test drive tomorrow

tahnx

alwaystootall

yeah those suckers can get seated on there pritty good,i just take a big rubber mallet and hit it in a spot where there is a bind in the pan like where it rolls under so i dont put a big dent in it. it will sooner or later come off there

Tilt

I used a medium sized prybar. Tried from all angles, but no go. then my friend does it from the front of the engine, and plop it came right off. I used a mallet too but that didnt do anything.

Speedracer32

coo
don't have any mallets
guess ima have to just keep bangin and hope for hte best

45psi

try to get in with a small screw driver, and then work up to a bigger size ect, ect, be careful of the gasket, unless you have a new one.

honda_joe

Start with the simplest first: are you SURE you got EVERY nut off? Theres like a billion of them stupid things...

crxfreak88

Go with a rubber mallet and tap it side to side. If that does not work try working in a small screwdriver without bending the lip. PATIENCE is the key.

Speedracer32

got it fellas
thanks for the quick responses
and ify your wondering, honda-joe was right
there where still two nuts but the trans that i couldn't see.

projekteg

you da man

88crxSi

some1 link this post to the "stupid things you've done while working on your car" thread. haha