oil feed
 

any one ever try to make an oil feed out of fuel line insted of the steel line before?
would it pop off too much? since it ruber it it gets to close would it melt?
any feed back would be great

Re: oil feed
 

I'd definatly not recommend fuel line, I tried along time ago and it ended up bursting and made a huge ass mess, I even thought it was a fluke and tried again and it blew up again. So trust me, it maybe rated for enough pressure but it just doesnt work, especially over time.

However, I have found that "weatherhead" hose from Napa works excellent, its not to spendy, its rated at 350psi, comes in perfect sizes 5/16 or 1/4. It has worked on many of our setups for long periods of time. I cant remember the exact price, but something like 4 or 5 bucks a foot.

https://www.homemadeturbo.com/turbo_...ooling_2_P.jpg

Re: oil feed
 

so for less then $30 i could make the whole feed for my 14b? would i be able to find the fittings?

Re: oil feed
 

yup, but you will need to get the factory banjo bolt & fitting. I usually leave about 4-5 inches on the stock pipe, then cut it and bend it the way I want. I then slide the hose over the pipe and put 2 hose clamps on it.


https://www.homemadeturbo.com/turbo_...st-fit_2_P.jpg

Heres a pic to give you an idea. Sometimes when you buy the turbo from the junkyard you can score the banjo/fittnig/pipe... Otherwise I think you will need to go to the dealer to buy it, which then it would be a rip off and cost to much. There really isnt a ------ way of doing it. I tried along time ago to force a brass fitting in there but it always leaked, mainly because the threads in the turbo are metric. Maybe you can score a cheap adater then go to a brass nipple.

Re: oil feed
 

im goin to go to the yard tomorow then and see if i can get a fitting cheap...i need a jpipe and o2 housing too.

Re: oil feed
 

i went to the hard and no luck......does any one have banjo fitting laying around?

Re: oil feed
 

i went to kragen and they have "oil cooler line" and thats only 2.00 a foot..any thoughts?

Re: oil feed
 

yea that might work ok, good luck scoring a banjo bolt and fitting though, maybe put something in the Wanted forum.

Re: oil feed
 

i tried the 7/16th fitting...too small..fits but not right, im goin to try to get a metric fitting, like a 12mm

Re: oil feed
 

Just to let you know the 14b uses M12 x 1.25 on the oil feed inlet