Oil Feed
Should the angled oil feed fitting go into the oil source or the turbo?
|
Re: Oil Feed
where is the oil line kit from? does it have one angled fitting and one staight fitting?
|
Re: Oil Feed
Originally Posted by daubleaaron
where is the oil line kit from? does it have one angled fitting and one staight fitting?
|
Re: Oil Feed
put the straight on the back and angled on the turbo
did you even look at the picture? |
Re: Oil Feed
Originally Posted by turboDA6
put the straight on the back and angled on the turbo
did you even look at the picture? pictures? wut pictures? are u referring to the tunertoys installation instructions? if so, none of my sheets have pictures for the feed line |
Re: Oil Feed
It will work both ways, but you'll be better off turning the block fitting until the outlet points in the general direction that your feedline will go. Put the straight one on the block fitting and route the line. Then the angled one goes into the turbo.
For T25, 14B, RHB5 turbo's the fitting going into the turbo is a straight as well. |
Re: Oil Feed
sounds good thanks
|
Re: Oil Feed
Originally Posted by cberman
Originally Posted by turboDA6
put the straight on the back and angled on the turbo
did you even look at the picture? pictures? wut pictures? are u referring to the tunertoys installation instructions? if so, none of my sheets have pictures for the feed line |
All times are GMT -5. The time now is 12:09 AM. |
© 2024 MH Sub I, LLC dba Internet Brands