obd1 injector harness install...
well, when a put my 450's in many moons ago, i was too cheap to get some obd1 clips, so i mutilated my obd2 clips to make them work ;D well, it pretty much looked like ass, and every now and then, my car would start to run like ----, well, the first place i would look would be at my injector clips and 9 times out of 10, one had popped off (imagine that). well, it just so happens that an obd1 intake manifold with a cut harness ended up in my drive way (seriously, some dude wanted me to do an mpfi swap for him, but changed his mind and said i could have the manifold), well, i decided to take the iniative to clean up my wiring a little bit, here's what i got.....
mutilated obd2 clips with taped up resistors looking like ass......... (it gets worse) http://www.newbieforces.com/files/77...7777777777.jpg close up of the assness..... http://www.newbieforces.com/files/66...6666666666.jpg ah yes, very ghetto, just how i like it 8) http://www.newbieforces.com/files/44...4444444444.jpg the new clips and obd1 harness cover, if you notice in the other pics, my plastic harness cover isn't mounted on the tab where it's suppose to be b/c the gay wiring that i initally did wouldn't quite allow it (note you still see the assness in the back round) http://www.newbieforces.com/files/55...5555555555.jpg obd1 clips with my stock cover on them, looking better already :D http://www.newbieforces.com/files/33...3333333333.jpg gotta love engine harness wiring :P i reccomend always soldering your connections when working with your wiring harness, i'm ghetto, but i'm not lazy(yes, those connections are soldered under the tape). http://www.newbieforces.com/files/22...2222222222.jpg and finally, the end result, much better compared to what i was working with ;) http://www.newbieforces.com/files/11...1111111111.jpg |
Re:obd1 injector harness install...
where'd the resistors go? nice work kevin.
|
Re:obd1 injector harness install...
Originally Posted by crx88Si
where'd the resistors go? nice work kevin.
;)i put them further down the harness so it didn't look like ass where you could see by the clips. i should have wired in a resistor box instead while i was at it, i guess i'll do that later. those ------ resistors are so damn bulky :P |
Re:obd1 injector harness install...
Shrink tube looks 100x better than electrical tape.
Get some. ;D |
Re:obd1 injector harness install...
i suggest puttin the resistors all stacked together like a "box". ;D
|
Re:obd1 injector harness install...
Originally Posted by crx88Si
i suggest puttin the resistors all stacked together like a "box". ;D
|
Re:obd1 injector harness install...
some wire loom and small black zipties will make it look better. i used wire loom to cover up my resistors, after checking to see if they got hot enough to melt the wire loom, i covered the resistors and the wires with wire loom and secured the wire loom with the small black zipties.
|
All times are GMT -5. The time now is 10:06 PM. |
© 2024 MH Sub I, LLC dba Internet Brands