notching the turbo for the adapter plate.
#1
notching the turbo for the adapter plate.
I have an HF manifold, a BMC adapter plate, and a DSM T25.
BMC recommended I get 25mm long studs for the turbo side, and i did, they stick out the holes on the turbo, but the surface where i would be putting the washer/nut is not flat. would it be ok to just notch that so its a flat surface? or what?
what have you guys done?
BMC recommended I get 25mm long studs for the turbo side, and i did, they stick out the holes on the turbo, but the surface where i would be putting the washer/nut is not flat. would it be ok to just notch that so its a flat surface? or what?
what have you guys done?
Thread
Thread Starter
Forum
Replies
Last Post
brax90si
Hybrid/Tech
3
02-02-2005 09:54 AM