Noob Gangbang!!!
#1
Noob Gangbang!!!
First post, so I'll just lay it all out and let you have fun with it.....
This is the set-up that I've come up with--
F23 - Bone Stock
Holset hy35 off late model Dodge - $77 @ pick-a-part
Ebay Special FMIC
38 mm Wastegate - Ebay
DSM BOV mounted within 6" of TB
Homemade MBC
Homemade catch can w/ level sight and drain valve
Homemade Log Mani (schedule 10 SS)
3" SS from Turbo back
3" high-flow cat, mid muffler, and oversized rear muffler (Sleeper)
460cc Injectors
I have a good source for metal pipe and tubing, so I'll be using thin walled aluminum for IC. All mandrel bends(IC & Exhaust).
Of course oil lines, and yes, I know, return goes down
OBD1 ECU (chipped with baseline, to be dyno-tuned upon completion)
I'm also gonna mount Boost and Oil Pressure Guages.
I'll be doing all of the welding myself, so when I do a write-up on the project, I'll have to title it "G-fab F23" or something
I think I'll be able to do it all for under $700.00, which ain't bad for 8-10 psi.
Feel free to give input, that's why I'm posting.
This is the set-up that I've come up with--
F23 - Bone Stock
Holset hy35 off late model Dodge - $77 @ pick-a-part
Ebay Special FMIC
38 mm Wastegate - Ebay
DSM BOV mounted within 6" of TB
Homemade MBC
Homemade catch can w/ level sight and drain valve
Homemade Log Mani (schedule 10 SS)
3" SS from Turbo back
3" high-flow cat, mid muffler, and oversized rear muffler (Sleeper)
460cc Injectors
I have a good source for metal pipe and tubing, so I'll be using thin walled aluminum for IC. All mandrel bends(IC & Exhaust).
Of course oil lines, and yes, I know, return goes down
OBD1 ECU (chipped with baseline, to be dyno-tuned upon completion)
I'm also gonna mount Boost and Oil Pressure Guages.
I'll be doing all of the welding myself, so when I do a write-up on the project, I'll have to title it "G-fab F23" or something
I think I'll be able to do it all for under $700.00, which ain't bad for 8-10 psi.
Feel free to give input, that's why I'm posting.
#5
They are internally gated at 20+psi. I'd like to make more than a few runs before I do a rebuild. 10psi or so is my goal. Unless of course, someone has figured out how to lower the setting on an internal gate without increasing lag. I could use the old foot gate, but I don't trust myself. Or a boost gauge, except to look for spikes.
#6
Thread
Thread Starter
Forum
Replies
Last Post
Smith-02
General Discussion
218
05-29-2007 05:22 PM
sanjiyan69
Forced Induction
27
08-02-2006 11:07 PM