my setup
 

;D aye sup guys my current build up just wondering how much boost is willing to take as a daily driver.

SRP 8.1 pistons

crower H beam rods

KINGS rods and main bearings

obx intake manifold

gsr tb 60mm

crower stage 1 camshaft

nkg one step colder

t3 42.48 trim

3' downpipe with no cat to apexi 3' muffler

tail 38mm wastgate (15psi spring)

how much hp you guys think i'm willing to get with this..

its going into a 94 civic coupe.

Re: my setup
 

so why did you build a decent set up and puss out on the tiny little turbo??

Re: my setup
 

your poopy turbo says you're maxed out around 250whp :-*

Re: my setup
 

:( wow its time for a new turbo...

Re: my setup
 

lol you were doing so good untill i read t3 42.48ar, get a bigger turbo and i could see that motor running 275-300 safely

Re: my setup
 

lol, I was sitting here going: :y :y :y :y through the build until I got to the .42/.48... then I went :-\. At least put a .60/.48 on there. I got one for sale if you're intrested, PM me.

Re: my setup
 

id only put that turbo on a d series motor. like fook said, that turbo is too small. a better turbo for that displacement would be a t3/t4 57 trim. unless you like to blow hot air and low #s.

Re: my setup
 

yeah that right a josh how much for that turbo? any pix..pix plz very intrested..oh btw anyone got an extra d16z6 block..in need of one for my REX..

Re: my setup
 

I can get you pics, but you'll have to wait a bit, I dont have it in my house right now, my friends has it in his garage. It has the typical Garrett crack beside the wastegate port, and a little side to side wiggle, but no in and out play, and it spins just fine. Id take 150 shipped for it.