metal gasket for DOHC ZC
#1
metal gasket for DOHC ZC
I've got a Cometic HP gasket for the D16. Problem is, the oil galleries don't match to my DOHC ZC block. I've always had the impression that all D16 engines have the same kind of blocks...obviously i'm wrong.
Does cometic supply the right kind of gasket for the DOHC ZC? I believe my block should be identical to the D16A1.
I'm looking for a metal gasket of 0.030 thickness.
Any recommendations?
Does cometic supply the right kind of gasket for the DOHC ZC? I believe my block should be identical to the D16A1.
I'm looking for a metal gasket of 0.030 thickness.
Any recommendations?
#3
Re:metal gasket for DOHC ZC
As far as I know HKS is the only manufactor for metal head gaskets for the D16a1/ZC head config. They have 3 different types and different thicknesses. They are very expensive, but work good.
http://www.wholehyper.com/old_site/hks-gasket.html
http://www.wholehyper.com/old_site/hks-gasket.html
#4
Re:metal gasket for DOHC ZC
thank abaz,
i'll probably get the HKS HG. I know they were available quite sometime ago, along with the camshafts, but many shops don't stock them anymore. I'll follow up with your link and check that shop out.
I'm running 75.5mm pistons, will the HKS 76mm HG work fine?
Thanks again!
i'll probably get the HKS HG. I know they were available quite sometime ago, along with the camshafts, but many shops don't stock them anymore. I'll follow up with your link and check that shop out.
I'm running 75.5mm pistons, will the HKS 76mm HG work fine?
Thanks again!
Thread
Thread Starter
Forum
Replies
Last Post
staticchmbr
Hybrid/Tech
4
11-03-2005 02:32 PM