Manifold to adaptor Problems
#1
Manifold to adaptor Problems
My exhaust keeps blowing out between the mani and my adaptor, this is due to my poor first time fab skills. So until I can make a new adaptor or order a BMC I need to find a way to stop it. Is there any good gasket material to use OR wil JB Weld hold the heat.
I was hoping to JB weld (use JB weld as a sealant , not as strength support because it hardens better than RTV Exhaust Sealant) it for the time being.
I was hoping to JB weld (use JB weld as a sealant , not as strength support because it hardens better than RTV Exhaust Sealant) it for the time being.
#6
Re:Manifold to adaptor Problems
Do not use sheet metal, it will not withstand the heat. I went through the same problem and the sheet metal brokedown and went into the turbo. Chipped some of the fins. I ended up using the stock maifold to turbo housing gasket on dsm's. I just doubled up the gaskets and have had no leaks. The sheet metal lasted for a couple of weeks.
#8
Re:Manifold to adaptor Problems
Originally Posted by 91SiSEZC
Do not use sheet metal, it will not withstand the heat. I went through the same problem and the sheet metal brokedown and went into the turbo. Chipped some of the fins. I ended up using the stock maifold to turbo housing gasket on dsm's. I just doubled up the gaskets and have had no leaks. The sheet metal lasted for a couple of weeks.
fyi i picked up the dsm gasket as well. its like a .5mm ceramic layer sandwiched between two thin sheet metal layers.