manifold adapter will it hold?
1 Attachment(s)
Hey sup guys this is my first post here
I bought a manifold and it fits great on the block but the turbo comes with a internal wg so it hits the block. I made a adapter , that rotate the turbo 30degree. I wonder if this adapter can hold the heat and weight, what do you guys think bout it? The pipe is mandrel bend exhaust, 13gauge or .09375 inch thickness Both 2 flanges is steel plate pure homemade 1/4thick This has not been installed yet and im goin to make a bracket attached to the block to support the turbo if it cant hold long. It looks like this: Attachment 21607 many thanks. |
Re: manifold adapter will it hold?
try it and see
|
Re: manifold adapter will it hold?
Solid HMT work :)
|
Re: manifold adapter will it hold?
flanges are a little thing but if they didnt warp you should be golden. The welds look solid :y
|
Re: manifold adapter will it hold?
Originally Posted by 88dx
flanges are a little thing but if they didnt warp you should be golden. The welds look solid :y
|
Re: manifold adapter will it hold?
looks fine. I've seen similar tube in use. however the thin flanges are worrisome.
|
Re: manifold adapter will it hold?
flanges may look bit small but they are made with harder material than the manofold's one
|
Re: manifold adapter will it hold?
just put two braces on each side to be safe. dont want the turbo to fall off by the welds breaking driving down the road. :S
|
Re: manifold adapter will it hold?
Keep in mind your oil drain. I can't tell what engine this is for but it looks like its gonna hang pretty low.
|
Re: manifold adapter will it hold?
I used an adapter like that with an HF mani, except I used a piece of 2.5" sch40 steel elbow with 3/8" flanges. It's worked fine, and even with the low oil drain, it didn't leak any oil. The key is the run the right size restrictor in your feed line.
Yours looks a little thin (14ga elbow?), but the welds look good. Just make sure to use gaskets, since 1/4" can warp enough to create leaks. But hopefully you welded it while bolted down... :P |
All times are GMT -5. The time now is 11:33 AM. |
© 2024 MH Sub I, LLC dba Internet Brands