I am looking for a flange or a bolt on flange to round pipe to fit a garret t3 turbo from a Ford 2.3 . I would like it to just be stright without any bends.

I am looking for one for the inlet and expecially the outlet. Any ideas where I can find something already made or just a steel flange that I can then weld pipe to?

Here is a picture of the turbo and the said flange. The bolt spacing is 2.75" and the hole coming out of the turbo is 1.5" I would like something that flares bigger becasue the opening on my IC is 2.5"



TIA,
Jake

 

looks like you have a gasket set there, have them made

 

they sell them at 5$ each at midas or most any other muffler shop. slotting the holes may be required, no biggy.

 

I assume you are talking about the compressor.

You can get the inlet elbows anywhere on e-bay or some other car site. I got one for $5 and then just cut the pipe off and welded an aluminum pipe onto it. For the outlet you can just use a DSM BOV flange and cut the bolt holes, also what I did.

 

i saw those at atpturbo.com

 

http://www.youtube.com/watch?v=9_b9RHHwlHc
This is almost as gay as you.