Just finished project (wont start)
 

I just cranked the car over and its not starting ill run down what i got 14b turbo/hf manifold dsm 450cc str fuel rail walbro 255 mbc hks ssq
turbo edit d16a6 is the motor any ideas or check list i should go threw i would really appreciate i been working on this for 4 months

***UPDATE***

Car starts now its was a fuse under the dash now the car acts like the fuel pump isnt clicking on all the time. it keeps blowing the alt solinoid fuse any ideas

Re: Just finished project (wont start)
 

can you hear the fuel pump prime? Will it crank over? Maybe try adjusting the fuel in turbo edit.

Re: Just finished project (wont start)
 

First check does it get spark. Then check does it get fuel. If you can solve those items your car will run. (unless the motor is damaged or the timing is completely off.)

Re: Just finished project (wont start)
 

did u wire the injector resistor box correct

Re: Just finished project (wont start)
 

Well when i did mine I was dumb and i put the turbo edit chip in the wrong direction :-[ It cranked but wouldn't start, check that out, could be your problem...Matt

Re: Just finished project (wont start)
 

Double check your connections expecially the ground.

Re: Just finished project (wont start)
 

i have a 89 crx si i didnt have to wire the resistor box in right? all i did to install the dsm injectors was grind the gromits pop them in and plug in the clips. exocron did my chipping services so iam sure the chips in the right way

Re: Just finished project (wont start)
 

i just went and cranked on it again (it tries to start) and it finally did for like 5 seconds and then shutoff i dont hear the fuel pump primeing itsself anymore again is there a fuse of some sort? this is my 1st turbo project and iam really clueless of why its not starting

Re: Just finished project (wont start)
 

could be the fuel pump relay, i had a similar problem after installing a walbro pump.