HomemadeTurbo - DIY Turbo Forum

HomemadeTurbo - DIY Turbo Forum (https://www.homemadeturbo.com/)

- Forced Induction (https://www.homemadeturbo.com/forced-induction-7/)

- - Intercooler Pipes (https://www.homemadeturbo.com/forced-induction-7/intercooler-pipes-130/)

kazkazaz

12-15-2002 06:52 PM

Intercooler Pipes

Hello all,
I was wondering if it is possible to use the existing piping from my cold air intake for plumbing for an intercooler. i am not sure how much psi it can hold, but i will only be running 5 lbs. of boost. And also, is there a certain type of tubing connector to use for a turbo ar can i just use regular connectors?

ucacrx

12-15-2002 08:02 PM

Re:Intercooler Pipes

depends, size does matter..

kazkazaz

12-15-2002 08:39 PM

Re:Intercooler Pipes

the piping is 2.25". Would that be too big to use?

leed	12-16-2002 01:50 AM

Re:Intercooler Pipes

Quote:

Would that be too big to use?
Report to moderator Logged

2.25ID sounds just fine.

v88dx

12-31-2002 12:42 AM

Re:Intercooler Pipes

wat if 2 inch pipes are used would that be no good?

beerbongskickass

12-31-2002 04:07 AM

Re:Intercooler Pipes

https://www.homemadeturbo.com/forum/...y;threadid=214

check this post out... it should answer your questions.

boostjunkie

01-01-2003 03:04 PM

Re:Intercooler Pipes

2 1/4 ain't bad but when i used it lag went up! really depends on what turbo you're usiing and how much boost. lower boost use 2", works well with smaller turbos. larger like 14b's should use2 1/4 because of capability.
happy boosting! ;D

All times are GMT -5. The time now is 04:42 AM.