insane boost creep/internal wategate adjustment
#1
insane boost creep/internal wategate adjustment
my set up: 99 d16y8:edelbrock kit, cut off the 2" flange at the end of the downpipe, no cat, 2.5" exhaust
boost will hold at 7psi until around 6K rpms then it will proceed to creep insanely, i think i saw 15psi once. i've been having this problem since i cut off the 2" flange, coincidential or not it really sucks...i tried moving the wastegate arm out but it still creeps to 10 from around a steady 5.
also what is the correct way to set an internal wastegate. i've heard that i'm supposed to hook up a compressed air source at the psi its supposed to be(7 psi)...then i don't know...
am i better off with an external wastegate? where would i put it on the edelbrock manifold? damn i'm like out of options, i've been posting on H-T, turbod16...i've been calling tech support lines
boost will hold at 7psi until around 6K rpms then it will proceed to creep insanely, i think i saw 15psi once. i've been having this problem since i cut off the 2" flange, coincidential or not it really sucks...i tried moving the wastegate arm out but it still creeps to 10 from around a steady 5.
also what is the correct way to set an internal wastegate. i've heard that i'm supposed to hook up a compressed air source at the psi its supposed to be(7 psi)...then i don't know...
am i better off with an external wastegate? where would i put it on the edelbrock manifold? damn i'm like out of options, i've been posting on H-T, turbod16...i've been calling tech support lines
Thread
Thread Starter
Forum
Replies
Last Post
OceanStateTuning
Forced Induction
6
05-26-2010 01:36 PM
CivicComingSoon
General Discussion
15
04-04-2004 08:13 PM