IHI RHB5 tech please
Guest
Posts: n/a
IHI RHB5 tech please
i have a HMT setup on my 95 civic DX (D15B7) with the IHI RHB5. It's a water/oil cooled turbo. My question is where do i hook up these lines? I know theres a feed and return line for both of them. So far i just got the return line from oil pan to turbo. I want to know where the feed line from the turbo goes. Am i gonna have to drill into the block? And where to hook up the feed/return for the water cooling part.
3.0 BAR
Joined: Dec 2002
Posts: 12,565
Re:IHI RHB5 tech please
on the back of the block there is a oil pressure sensor on the left hand side of the oil filter, you need a 1/8 bspt to npt fitting, on the ihi the water inlet and outlets have the same size fitting, its flared at the tip. the oil inlet on those turbos stock was a hard line. if it was removed there should be a npt fitting screwed into the center cection directly above the oil return fitting.. to run the coolant lines you need to tap into the coolant source running to the throttle body and intake manifold.
if all else fails reed the faq.
if all else fails reed the faq.
3.0 BAR
Joined: Feb 2003
Posts: 9,089
Thread
Thread Starter
Forum
Replies
Last Post
Xemu
Fabrication
11
Apr 8, 2007 09:56 AM
juli0_bustamante
General Discussion
23
Aug 19, 2004 07:04 PM
