IHI oil line ?
#5
Re:IHI oil line ?
on my IHI VJ11 the oil feed fitting that screws into the centre section housing doubles as a restrictor, very small, maybe 1 mm orifice in the middle, your going to want to make sure you keep that, or you'll be getting too much oil to the bearings.
The thread on the other side of the restrictor seems to be 1/8 BSP, the same as the oil sender. I used a 1/8bsp female to 1/8 NPT female adapter, and some SS braided line from mcmaster.com
Neil
The thread on the other side of the restrictor seems to be 1/8 BSP, the same as the oil sender. I used a 1/8bsp female to 1/8 NPT female adapter, and some SS braided line from mcmaster.com
Neil
#6
Re:IHI oil line ?
I used a 1/8th fitting and just threaded the ****** in there... I used like a 3 inch extension with a barbed end so that the line could clear the adapter plate and just hooked up the oil lines from there.
That trip to Lowe's was seriously over an hour's worth of trial and error. It sucked.
That trip to Lowe's was seriously over an hour's worth of trial and error. It sucked.
Thread
Thread Starter
Forum
Replies
Last Post
oxsleeperxo
Forced Induction
10
12-13-2004 10:25 PM