how to test your wastegate
 

Does anyone know how to test your wastegate while its not on your turbo... I heard something like using a air compressor or bicycle pump.... does anyone nkow?????????????

Re:how to test your wastegate
 

well, i was thinking about this the other night. what if you put some thick rubber over the exit side of the compressor, and somehow got a pressure gauge attached to it, then you could just run a leaf blower or something through the exhaust inlet, and see at what PSI the gate opens....OR, just remove the spring and add weight to the spring until it starts to collapse, that' would be close.

Re:how to test your wastegate
 

hand pump with a gauge.

Re:how to test your wastegate
 

i invented this method:
best and most incredibly accurate way to test the wastegate is to do this

take a long length of vaccum hose
take a plastic or brass tee that fits the vacuum hose
attach one end of the vacuum line to the wastegate. and one end of the tee attach to the boost gauge tubing.
next connect the last end of the tee to an air compressor, doesn't matter how powerful it is.

then put the wastegate on top of the windshield ouside the car and with you inside the vehicle with the air compressor in your hand give it a few shots of air and look at the boost gauge as to when it causes the arm to push out. this is the point you wanna concentrate most on. and go past that point about 10psi and slowly leak some of the pressure in the vacuum line (however you wanna do it) and bring it down one psi at a time until you figure out exactly what psi the wastegate closes at, and that point is close to what the wastegate is set at. its probably one psi above what its at when the wastegate shuts closed.

Re:how to test your wastegate
 

i have a 6hp air compressor with a 30 gallon tank... u think i can use that in anyway.... it has a psi guage on it that shows how much is running though the line

Re:how to test your wastegate
 

6hp seems a bit much to test a spring in a wastegate. damn stock crx's have less hp than that.

Re:how to test your wastegate
 

u could use a bike pump with a gauge...

there are vacuum pumps. i duno if you rig it up to push air..

Re:how to test your wastegate
 

Hey hey hey.. I've seen guys put Type-R oil caps in thier stock CRXs and dyno at 11hp! ^_^