Hondata Intake Manifold Gasket
#1
Hondata Intake Manifold Gasket
Anyone here using it? Any noticable gains on the butt dyno?
And does anyone know if any of our sponsors carry this product?
I'm pretty sure I will be purchasing one shortly, strictly as a safety measure...it would be a bonus to see some increased horse power though as well
And does anyone know if any of our sponsors carry this product?
I'm pretty sure I will be purchasing one shortly, strictly as a safety measure...it would be a bonus to see some increased horse power though as well
#3
Re:Hondata Intake Manifold Gasket
Yeah they do...I inquired about it sometime back from a vendor on H-T...if I remember correctly it was about $65 shipped which ain't too bad I figure for cooler intake temps and less heat soak in the IM
#4
Re:Hondata Intake Manifold Gasket
i have one from AN-R.... doesnt seem to do ----, intake manifold still gets too hot to touch...even with no coolant going to the IACV, TB, stupid thing below the TB...hell no coolant to anything but the thremostat and still hot as ----... it may take it longer to heat soak in? but i dont have datalogging so i cant tell
#5
Re:Hondata Intake Manifold Gasket
I have one on my b18c1 turbo. I can tell a difference because last year when I went to the track, I could NOT touch the IM in between runs.
When I did go this year the IM was to the point that you could put your hand on it and keep it on and not burn your hand. 98ctr
When I did go this year the IM was to the point that you could put your hand on it and keep it on and not burn your hand. 98ctr
#10
Re:Hondata Intake Manifold Gasket
I could NOT touch the IM in between runs.
When I did go this year the IM was to the point that you could put your hand on it and keep it on and not burn your hand
When I did go this year the IM was to the point that you could put your hand on it and keep it on and not burn your hand
Its mostly a way of controling the rate at which your IM heat soaks, vs the end temp it will ultimately reach while sitting. After just 8-10secs of decel in gear your IAT temps can jump as much as 15-20*. These gaskets slow that rate dramatically.
FYI, leaving your engine running will increase your IAT's at a MUCH slower rate than turning it off for short periods. Thats my datalogging experience atleast.