Hmm, so my wastegate actuator has a leak
#1
Hmm, so my wastegate actuator has a leak
If you suck on the hose, you can suck air thru the hose pretty bad, but if you blow on it a bit, it stops leaking and holds the pressure, but i bet at 10psi it might leak still. Im thinking that my wastegate is causing my wierd boost issues... like getting 9ish psi instead of 10. Has anybody else had a wastegate that leaked a little like this? I know youd think that the boost would increase due to the can not holding air in it, but i think that its leaking thru the can because the can still holds pressurized air for the most part... but iit leaks during vaccuum... wtf?
#2
Re: Hmm, so my wastegate actuator has a leak
A simple test is to disconnect the armature from the swing arm (actual wastegate) pull the armature and place a finger over the wastegate nipple. If it is good, it should hold vacuum and the armature should stay extended. Let go of the nipple and it should snap back.
#3
Re: Hmm, so my wastegate actuator has a leak
ehh it was sketchy so i took it apart, and it has a 1/8 iin hole in the middle of the diaphram and a 1/2" slit in it too. Im gonna see if i can get another or possibly swap diaphrams or somthing.
Thread
Thread Starter
Forum
Replies
Last Post
accordepicenter
General Discussion
9
05-12-2005 11:18 PM
ReignOfChaos
Forced Induction
7
08-01-2003 10:08 PM