help me out fellas
 

ok here is my dilema,

Driving around tuning, get a good 2nd gear pull, pull into the gas station to make some changes in the higher rpm's. burn the chip and throw it back in, but the vacume is only at 16 instead of 20 and it idles like its missing. reburn the chip, see if it got messed up but nothing. The chip is in there secure and all the pins are where they are supposed to be. After a couple time is reburning the chip with the same maps, the car wont start, it turns over but doesnt start.

So i grab my other ecu, reburn a chip and see is my ecu is fucked, but no its the same thing, all of a sudden my car wont start. So i get towed home, tried to start the car and it tries to start but just dies.


i have fuel, i have spark, i know the chip burner works cuz we tested it out on my buddies car.

Anyone have any ideas of what might be the problem(s). I am clueless and because of my car not starting i am missing work tomorrow. GIVE ME SOME IDEAS GURU's

Re: help me out fellas
 

Did you install the chip in the right direction? You might have installed it backwards and that would prevent the car from starting.

Re: help me out fellas
 

i think you will get more feedback from Fuel Management Forum.

Re: help me out fellas
 

he's way ahead of you, he posted the same thread in FM 2 minutes and 29 seconds after posting this one. ::) That was one slow copy paste job :P

Re: help me out fellas
 

nope chip was in right direction, we spent about an hours reburning chips to see if the burner or the chip we wewre burning was meseed up, but they are both fine