help i think i fuc*** something up
#1
help i think i fuc*** something up
ok i had to break the turbo apart to tap the oil fitting
now i put it on a press did it a little i thought it was still hard so i press a little more i heard a pop now the housing spins what the ---- did i do
its a baby 13g tdo4 it keeps spinning what did i do im mad
now i put it on a press did it a little i thought it was still hard so i press a little more i heard a pop now the housing spins what the ---- did i do
its a baby 13g tdo4 it keeps spinning what did i do im mad
#2
Re: help i think i fuc*** something up
i did the same with my t3 to rotate the center section to make my oil drain legid.
usually they have lik bolts / plates that just pops off .
wat do u mean by keeps spinning ? the whole center section?
usually they have lik bolts / plates that just pops off .
wat do u mean by keeps spinning ? the whole center section?
#5
Re: help i think i fuc*** something up
so your compressor is free spinning on the center section?
odd. try pulling that snap ring and take it out, then just put it back together. theres supposed to be a little tab that holds it in a certain position.
odd. try pulling that snap ring and take it out, then just put it back together. theres supposed to be a little tab that holds it in a certain position.
#7
Re: help i think i fuc*** something up
this is without the vband clamp holding together right?
most likely the plate cracked thats right under the exhaust wheel. (the heat shroud)
similiar to #16
if it looks good just tighten down the clamp.
most likely the plate cracked thats right under the exhaust wheel. (the heat shroud)
similiar to #16
if it looks good just tighten down the clamp.
#8
Re: help i think i fuc*** something up
Originally Posted by whiterice
this is without the vband clamp holding together right?
most likely the plate cracked thats right under the exhaust wheel. (the heat shroud)
similiar to #16
if it looks good just tighten down the clamp.
most likely the plate cracked thats right under the exhaust wheel. (the heat shroud)
similiar to #16
if it looks good just tighten down the clamp.
Thread
Thread Starter
Forum
Replies
Last Post
yayopwrcrx
General Discussion
10
06-30-2004 04:58 PM