does this turbo have a wastegate on it already?{i think it does just double checking}. would this make a good turbo at 7 psi? http://www.obsidiansales.com/july29/DSC09892.JPG http://www.obsidiansales.com/july29/DSC09891.JPG

 

It does have a wastegate actuator though... but that's pretty much it.

 

does it look like it will work good it sais it has no shaft play and turbo spins freely

 

those turbos are fine. what's the price though? and does it come with the compressor inlet or the exhaust housing/wastegate flapper?

 

idk wat a wastegate flapper is . $40 for it so far. http://www.obsidiansales.com/july29/DSC09895.JPG http://www.obsidiansales.com/july29/DSC09890.JPG i dont want to rebuild a turbo because i dont kno how and i will probly ---- it up . and i only have like $500 to spend on my whole setup ..

 

Chrysler T3's are fine. The only gay thing is the Chrysler exhaust T3 flange. It will not bolt to your standard T3 manifold. If your making your own mani, then I guess its no big deal. Later on down the road when you get bored w/ it and decide to try out a larger turbo, your gonna be pissed that you have to modify your manifold. :P

 

there is enough room on the turbine inlet to drill it out for a reg T3

 

Good idea.
Have a blast drilling a cast housing. Just use someone elses bits/drill press,

 

a drill press and about a half an hour will get the job done. just go slow and use a nice carbide bit

 

rodman bits life time wantayy they beack u get a new one