EG Fog lights vs. Intercooler Piping
 

I want to keep my OEM fogs on my EG.....is there anyway I can route the piping to do this?

Re:EG Fog lights vs. Intercooler Piping
 

Really depends on how the intercooler is setup, what do you have?

Re:EG Fog lights vs. Intercooler Piping
 

Well nothing yet.....but since I am only going to run 8 psi or so I'll get a smaller IC.....maybe 16-18'' core size

Re:EG Fog lights vs. Intercooler Piping
 

I've seen a couple EG running a FMIC with the factory fogs. Depending on your setup you should be able to work around them.

Re:EG Fog lights vs. Intercooler Piping
 

With a smaller fmic it would work but with something about the size CCA cooler I doubt you could keep the fogs.

Re:EG Fog lights vs. Intercooler Piping
 

If you could route your pipes without going around the frame of the car, you could do it.

Re:EG Fog lights vs. Intercooler Piping
 

you can do this with the starion ic.

Re:EG Fog lights vs. Intercooler Piping
 

flip the intercooler upside down, making the in/out of the intercooler on the top.

Re:EG Fog lights vs. Intercooler Piping
 

that is what I was thinking. Something with rear-facing outlets and relatively short.

Re:EG Fog lights vs. Intercooler Piping
 

As someone said above it's very difficult with something like a CCA intercooler; unless you get very creative with your charge piping. Lots of bends. Hope you like to weld.

Re:EG Fog lights vs. Intercooler Piping
 

with the CCA, the fog lights will fit if you make the charge pipe angle tight enough.

Re:EG Fog lights vs. Intercooler Piping
 

Actually I was thinking of just using 2.25-2.5'' silicone tubing for charge pipes.

It's flexible and heat resistant...and is good up to 45 psi or so....

Re:EG Fog lights vs. Intercooler Piping
 

Fog lights were cool back in like 1996... intercooler piping is way sexier.

http://users.adelphia.net/~pshickey/images/FMIC.JPG

Re:EG Fog lights vs. Intercooler Piping
 

The silicone tubing isn't all that flexible. You will have to buy bends that cost an arm and a leg, and you still need to use some pip to connect the silicone pieces.

There is a reason everyone uses steel bends.