DSM 450 install question?
 

I read the post in the FAQ and tell me if this sounds right.
-remove two bolts holding down the fuel rail
-pull off fuel rail
-disconnect clips
-pull out injectors

Is it that simple?? The only thing holding down the fuel rail and injectors are those two bolts?? And as for my questions.

-Can you use the stock clips on my b18b on the DSM injectors?
-It says that the DSM's won't fit flush with the stock seals...is it crutial that they are not flush?
-I'm assumeing that the injector seat is tapered that's why they dont sit flush...if I do have to flush them up will boaring them out with a dremel work fine? And seal good?
-It says to use "lube" on the injector seals for install..what kind of lube should I use?


Thanks for any help or suggestions.

Re:DSM 450 install question?
 

Can you use the stock clips on my b18b on the DSM injectors?

all you have to do is cut the little bit out of the plug, you will see what i mean if you pull the plug off and try and get the new ones to fit!

It says that the DSM's won't fit flush with the stock seals...is it crutial that they are not flush?

mine are about 2 mm sticking out of the seals and no leaking

-It says to use "lube" on the injector seals for install..what kind of lube should I use?


I used spit! it worked a treat for the lube!