chipped fins
#1
chipped fins
ok i just bought my 14b setup a couple of weeks ago and i was just inspecting my turbo and noticed the fins in the compressor housing are a little chewed up. this turbo has very minimal shaftplay and didnt leak a drop of oil. my question is.... Would you HMTers use this turbo? i only plan on running 8-10 pounds max. maybe ill try to get a pic tomorrow but they just feel a little chipped up. i plan on getting a filter for this thing because i dont think the guy before me used one.
#5
Re: chipped fins
so they are messed up because something got in there where there wasn't a filter? or are they messed up because they contacted the housing?
i have one that contacted the housing on the turbine side, and every fin has a chunk out of it. if its nothing major that you dont' think woudl throw off the ballance at about 125k rpm, then run it, otherwise look somewhere else
i have one that contacted the housing on the turbine side, and every fin has a chunk out of it. if its nothing major that you dont' think woudl throw off the ballance at about 125k rpm, then run it, otherwise look somewhere else
#7
Re: chipped fins
haha exactly xternal, whats the worst that'll happen? you'll spool it up and it'll loose balanace bounce off the housing chew up the fins more before snapping the shaft and sending the exhust compressor out your zorst,
solong as its not missing any fins it should be fine man
solong as its not missing any fins it should be fine man
#8
Re: chipped fins
Originally Posted by PaRaDoX
haha exactly xternal, whats the worst that'll happen? you'll spool it up and it'll loose balanace bounce off the housing chew up the fins more before snapping the shaft and sending the exhust compressor out your zorst,
solong as its not missing any fins it should be fine man
solong as its not missing any fins it should be fine man
Thread
Thread Starter
Forum
Replies
Last Post