ok we just finished putting a kit on a 95 civic with a single cam zc running stock injectors and a s-afc set at +25 low throttle and +30 at high we have the blox by-pass vavle too but he is still throwing a check engine with his car gets into the high rpm were vtec would usually be but we have vtec set to turn on at 8000rpm so i dunno whats up

 

i dont know about all that but why would u set vtec to 8000 rpm.

 

um, what is the cel code? how did you set vtec with an s-afc? and if you meant to say v-afc, it doesn't matter where you set vtec on a non vtec motor, you just don't hook up the wires.

 

you need a missing link

 

the single cam ZC is vtec and i have the blox by-pass vavle which is the same as the missing link it goes between the t/b and the map sensor and i set the vtec in 8000 rpm because i dont want it inguaging we found out what it was it is the 02 sensor so im going to have to get money and replace that

 

You should invest into some 450's first.

 

+30 !?! you'll get a MAP code soon man

 

hahahah + 25 on stock injectors
get the jb weld ready

 

Seriously. Put the keys down and get some decent fuel goin in there and don't boost until you do.