Charge pipes ??
Im almost done with my swap/turbo and i was installing my charge pipes, and im not sure about going from the turbo to the intercooler. Its a 95 civic, with a b18b. My thought was to ditch the washer fluid pump, and find a smaller one to relocate or put where the stock one is just so that it sits higher,....
what do yall do to get it to work,,, the bumper wont go on if i run the pipe under the washer resevour... |
Re: Charge pipes ??
I ended up removing the washer fluid reservoir which is the easiest way to go, but it's possible to go above/around it.
|
Re: Charge pipes ??
Remove it and just rock a spray bottle. Do what you must to satisfy the boost gods.
|
Re: Charge pipes ??
Backdoor intercoolers = clean windows 8)
|
Re: Charge pipes ??
i took mine out. just wash the window every time you get gas and/or have a bottle of water/windshield fluid in the car
|
Re: Charge pipes ??
Originally Posted by Atticus
i took mine out. just wash the window every time you get gas and/or have a bottle of water/windshield fluid in the car
|
Re: Charge pipes ??
ive never had to take that off, even in my crx with ls and super tightness.
on egs is super easy to have the compressor outlet facing down and do a 90 and just go under the washer bottle and under everything else. get creative. ;) |
Re: Charge pipes ??
I always went under. if you have a steel charge pipe then you'll be fine. Mine were plastic and I scraped them and they still held up till I hit a dead deer one time and it collapsed the piping. I just replaced it for cheap.
|
Re: Charge pipes ??
well i have to have the botle of bug juce to pass inspection, cause i dont even have this car on the road yet :-\
and im out of mandrel bends to get around the bottle, but ill figure it out, im a try to relocate it.. |
Re: Charge pipes ??
but you can pass inspection with a turbo setup on?
|
Re: Charge pipes ??
yea i can pass with a turbo, ;) , and it will pass emissions after i visit Xenocron :P lol
Is the front bumper suport brace nesicary on an 95 civic, it dos not look that structural :l It is preventing me from using the larger IC i have, lol, id rather use the bigger on i got, but it sits to low with the suport bar there,....if it wasnt there i would not have trouble routing my pipes any more lol.... |
Re: Charge pipes ??
to pass inspection all you have to have is injectors in your hood that look like there hooked up to something if they get picky or you want to just swap the bottle in when you go for it thats what my budy did
are you talking about the rebar? |
Re: Charge pipes ??
Originally Posted by igotnothin
Is the front bumper suport brace nesicary on an 95 civic, it dos not look that structural :l
|
Re: Charge pipes ??
well good news is my neighbors, have a race stang and they do all ther fab work....they dont weld aluminum, but there budy up the road dose, so im a get him to come down with his truck, and maby i can limit the whole set up to just 3 couplers ;) so :)
|
Re: Charge pipes ??
Gatorade Bottle FTW ;D
|
All times are GMT -5. The time now is 04:35 PM. |
© 2024 MH Sub I, LLC dba Internet Brands