Charge Pipe Question
 

Kind of a newb question.... but I am able to hook up charge pipes using only couplers and piping... or is it not a good idea because most people around here seem to get all their pipes welded...

could I just buy a charge pipe kit... cut it to the right length and bends... use the couplers and be good to go???

thanks

Re: Charge Pipe Question
 

for your typical HMT setup that will be fine. Make sure you use bar and plate clamps/ Tbolt clamps

IF they start to blow off you can bend the end a bit, put some hairspray on the pipe, etc... good to 20psi or so.

Re: Charge Pipe Question
 

Ive run all sorts of IC pipe setups that were less reliable than the one you just described and have had very few problems on any of my builds.

Either way is perfectly fine.

Re: Charge Pipe Question
 

how many t-clamps and couplers do you think I would need for a fmic setup on an EK???

Re: Charge Pipe Question
 

Get 7 couplers and 14 clamps to be safe, you may be able to do it with 5 or 6.

Re: Charge Pipe Question
 

anyone know a place that sells cheap, good couplers and t-clamps....

I was also looking at the tuner toys charge pipe kit http://www.tunertoys.com/TunerToys_C...p/cpk250hc.htm ... looks good to me.... anyone know of anyones that are just as good for cheaper?

Re: Charge Pipe Question
 

Nope.

Re: Charge Pipe Question
 

LSD Motorsports (forum sponsor) has the best prices on couplers Ive ever found.

Re: Charge Pipe Question
 

Home Depot nigga

Re: Charge Pipe Question
 

or lowes if your not lucky enough to have home depot.

You can get most of the charge piping items at most hardware stores unless your serious in the boonies. Well all boonies have a hardware store that backs as the local grocery :6