so i finally did it, i turboed my dohc zc well i had a buddy of mine burn me a chip from hondata and i put 450cc injectors in and wired them up to the resistor box and it started up with a rough idle and then i pulled up the driveway and turned down the road and turned around and came back up and went to back it into the garage and then it quit and now it wont start again, i have no clue what is wrong with it, im gettin spark, fuel, but im have on 89 octane in it i think i need to have 93 or higher, but i dont understand why it wont start, another buddy of mine said i might of got a bad burn on my chip

 

dud reburn it and eliminate that possiblity or check the ecu in another car that runs

 

the ecu is good b/c if it wasnt it wouldnt be kickin the fuel pump on

 

wrong fuel pumps are run buy the power from the batery not the ecu look at my sig if you dont believe me,

 

^^^ hey the man didnt get the ASE shoulder patch for nothing i agree with him 100%

 

but i know im gettin fuel the pump is kickin on and there fuel goin to the fuel rail and the computer is good

 

duh ever think that the timing and or the fuel maps are off or have a hole in them

 

take the computer out and turn the key i bet the fuel pump will work..... :1 re burn the chip or get another computer from another car and check it minimize the problem by checking the small things.

 

read the post i already said that

 

the timming cant be off unless he jumpped time because he said he drove the car then when he came back the car died.......he is getting fuel, spark, i would say check the compression just in case that the car jumpped time and bend some valves IMO