just got done with install last week, just now having time to check codes, im getting the obvious 3(map) but am also getting a 22(vtec pressure switch) its says that vtec operation is determined by rpm, mph, tps, map sensor, and coolant temp. my question is would the map sensor being off have anything to do with this or do i have a seperate prob in itself? thanks for any help

 

ok, i have all codes fixed and cleared...after clearing the codes i drove the car down the road to get the map cel to come back on so i could check and make sure that was the only one i had, but after getting into 1-3 2 different times it never came on, does that make sense? im running a t25 on a d16z6, at around 5-5.5 psi is it possible that im not making enough boost to throw it off or should i expect it to come back on again later?

 

vortech fmu for management

 

not yet, waiting on missing link, should be here tomrorow

 

sorry i was getting the map cel due to no missing link or check valves, but now that ive cleared them out and run the car down the road in boost it didnt throw the map again, any idea whats going on?

 

ok, i gotcha, my missing link should be here tomorrow, hopefully, so no matter if the cel is on or not its still a good idea to install that then?