b16injectors
Hi im new here just had a question i was at the JY the other day and found a turbo laser was wondering if anyone knew if there 450cc? and if they are will they clip straight in ? running obd1
|
depending on if it was auto or stick it would be 390 or 450cc injectors. you have to drum sand out a little bit of the bottom o ring on the intake manifold for them to fit nicely in there and you need to run a resistor box or inline resistors on the power wire. also the plus its self there is a little tab on the inside that you need to take a razor blade and trim it off so that your obd1 plugs fit
|
if it was an awd laser than they are 450's
|
even better than sanding out the o-ring if you kinda push them in with out sanding then tighten the rail down on them it works bvetter because you dont get the chance of getting a vacuum leak
|
not to start a fight but i did that and in about 10k miles one of them must have hardend slightly and it ripped and caused me to lean out one cyl.
|
just make sure that they are pushed all the way inn
|
and i wasnt saying hog them to hell just take the little rib in the middle out
|
just go to your local shop and get o rings super cheap
|
actually 4 o ring kits will pry cost more than the inj themselves there like 12$ a peice. if they were so cheap why would we be sanding our stock ones out
|
All times are GMT -5. The time now is 05:11 AM. |
© 2024 MH Sub I, LLC dba Internet Brands