B00sted D series head gasket choices.
 

Ok,

I am building a Mini-Me a6/y8. I have the Honda metal gasket incoming, and the ARP head studs as well for the y8. The point of this question is this: Is it better to go with an aftermarket gasket than the honda piece? I generally prefer honda factory parts, however honda factory parts were not inteded for b00st. So I thought I would put it out here, and ask.

Whats the best way to go?

Thanks,

Re: B00sted D series head gasket choices.
 

your basic metal 3 layer headgasket works just fine.

ive run oemor just basic parts store brands like beck/arnley and fel-pro, and stone...they all do just fine

Re: B00sted D series head gasket choices.
 

If you're going for big boost, highly built d-series, then check out these suckers ;Dhttp://www.cometic.com/phuzion.aspx But Fook's right...for your everday build, any MLS is just fine.

Re: B00sted D series head gasket choices.
 

Give both sides of it a nice thin coat of copper spray for extra insurance, and you're set.

Re: B00sted D series head gasket choices.
 

oe metal gasket is fine

cometic gaskets fit like poop


u can make alot of power on stock metal gaskets and arp studs

Re: B00sted D series head gasket choices.
 

OEM ftw

Re: B00sted D series head gasket choices.
 

Im running an oem y8, arp studs @ 15psi and Ive had no issues

Re: B00sted D series head gasket choices.
 

is there a top and a bottom for the y8 headgasket? I just bought one and dont wanna put it on upside down. I looked and there is no up on it. Thanks

Re: B00sted D series head gasket choices.
 

where do you guys normally get your headgaskets. i was considering the tuner toys cometic but someone just stated that fit like ass.

Re: B00sted D series head gasket choices.
 

Either direct from Honda, or whoever sells them cheapest around here. Partsource, Autozone, etc.